This will help if you installed an incorrect or mismatched driver. Try to set a system restore point before installing a device driver. It is highly recommended to always use the most recent driver version available. That being said, click the download button, get and apply the new version, and check back with our website constantly to stay up to speed with the latest releases. It is recommended that you perform this step in a steady power environment such as the one ensured by a UPS unit, and that you don't interrupt the upgrade in any way, because this might cause the switch to malfunction. First off, go to the system information page of the switch to check that the currently installed version isn't either newer or matching this release.Īpplying a new firmware can decrease the security vulnerabilities, enhance overall performance and compatibility, improve various power management functions, resolve different errors, and add support for newly developed technologies and protocols. Usually the update procedure isn't much of a hassle as manufacturers try to make it as simple as possible however, there are cases that are exceptions to this rule. Given the large variety of models and different methods for upgrading the switch, if you wish to apply this package, we recommend that you read and understand the installation steps before you install a new firmware, even if you are a power user. After the switch is restarted, login the switch to double check whether the FW is upgraded correctly, via GUI page of “GUI page System > Management > System Information”.

The restart may take several minutes, do not power cycle or reboot the switch before the process is complete. Go to GUI page ‘Maintenance > Reset > Device Reboot’, check the checkbox then click Apply button. If not, go back and download the switch image again. Go to GUI page “Maintenance > File Management > Dual Image > Dual Image Status”, to double check the latest image is correctly downloaded to image1 and image1 is the ‘next-active’ image. Do not power cycle the switch before the success message shows up as below. The download will take several minutes. rom format stored in local PC via Browser button, then click Apply button to start firmware downloading. Suppose the backup-image, then go to “Maintenance > Download > HTTP File Download”, set File Type as ‘Code’, set Image Name as ‘Image1’, select the firmware file of. Go to GUI page “Maintenance > File Management > Dual Image > Dual Image Status”, find the backup (next-active) image. Download and unzip the new firmware and store it in local PC. Firmware Upgrade procedures by using web browser:

Switch firmware download